|
Product introduction
Тестер блока питания (Power Supply Tester) - простое
средство диагностики состояния Вашего блока питания с 20-
контактным или 24-контактным разъемом. Позволяет проверять
параметры разъемов питания: 20/24pin (ATX-connector), +12V,
-12V, +5V, -5V, +3.3V, 5V stand by (SB) 12 power Good (PG),
Floppy, HDD, CDROM, SATA, 4 pin (P4), 8 pin (Dual-CPU), 6
pin (PCI-Express) стандарта ATX, BTX и ITX.
The methods
of operation
A. Plug power supply 24PIN and P4, P6 or P8 into the
corresponding jack of the power test suit.
B. Power on the supply of power, will hear DuDu ring, if no
flicker then the power supply output voltage is normal.
C. If a certain voltage signal is not detected, or the
detected voltage value over the normal, will issue a DuDu
long buzzer; if the corresponding voltage value or PG
flicker too, then the power is failed.
Specification
Voltage source: 20/24pin (ATX-connector)
voltage test: +12V, -12V, +5V, -5V, +3.3V, 5V Stand by(SB),
12V Power Good(PG)
Connectors: Floppy, HDD, CDROM, SATA, 4 pin(P4), 8
pin(Dual-CPU), 6 pin(PCI-Express)
|
